Sagem F@ST 1400W Guida Utente Scaricare il pdf (Pagina 9)

Installing the hardware 8

SAGEM F@st™ 1400 / 1400W

2.2 Powering up the modem/router

• Connect the cable (4) to the PWR port located on the rear panel of the modem/router.

• Connect the power pack to a nearby socket.

• Set the On/Off switch (I/0) to On (the "I" position).

The PWR LED comes on.

In no event should you connect your modem/router to a single computer using

the USB and Ethernet cables simultaneously.

You can now connect your computers to the SAGEM F@st™ 1400/1400W

modem/router:

• via the USB interface,

see chapter 4 "Connection via the USB port" ........................................................ page 12

• via the Ethernet interface,

see chapter 3 "Connection via the Ethernet port" ................................................. page 10

• via the wireless network interface (SAGEM F@st™ 1400W only)

see section entitled "Configuring the wireless network" ........................................ page 22

After a few minutes, the modem/router is

automatically synchronized with your ADSL

line. The LINE LED comes on permanently.

On/Off switch (I/0)

(4)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Nessun commento

Sagem F@ST 1400W Guida Utente Pagina 9